Goal: Setup and run Wireless LAN traffic using the LANforge CT521.

In this test scenario, the LANforge CT521 is used to simulate 4 virtual wireless stations that associate with a third party access point. Three traffic tests will be configured and run to demonstrate possible wireless access point tests.

1. Create the virtual wireless stations.
Note: All of its virtual stations will use the same wireless AP in this example, but each station may be configured for a different AP as long as all stations on the same radio use APs on the same channel.

A. Go to the Port Manager

B. Select port wiphy0 and click Create

C. Select the Wifi STA button, then enter MAC, Quantity, STA ID, and SSID. Select the DHCP-IPv4 checkbox:

a. In this example, all 4 virtual stations will connect to the same access point
b. If your access point can serve DHCP, you can select the 'DHCP-IPv4' checkbox here to enable each virtual station as a DHCP client
c. If you choose to enter IP addresses manually, the create function will increment the last octet of the IP address for each virtual station created
d. Click Apply when finished

D. Verify that the virtual wireless stations are created

E. Scroll to the right to view each station's link quality and other interface details

2. Create Layer-3 connections between the station interfaces.

A. Go to the Layer-3 tab and click Create

B. Create a station-to-station UDP speed test:

a. Test 1: sta0-sta1, UDP, 100Mbps ↔ 56Kbps

C. Create a station-to-station TCP speed test:

a. Test 1: sta0-sta1, TCP, 1.54Mbps bi-directional traffic

3. Run traffic tests concurrently, and view results.

A. The AP in this example has a weak signal strength, so it can do only about 35Mbps total throughput. The round-trip-time (RTT) is reasonable, and there is very little packet loss.

B. The Layer-3 Endpoints tab has more detail.

C. Select the cross-connects or endpoints and Right-Click → Dynamic Report on the L3 Endp or Layer-3 table to view a live report of the connections.